攪拌車系統氣壓不足是什么原因造成的呢？我們又該如何去檢查與維修呢？下面小編為您詳細解答下。

What causes the insufficient air pressure in the mixer system? How should we check and repair? The following is a detailed answer for you.

如果全自動混凝土攪拌車液壓泵有油輸出的情況發生，我們可以及時查看其工作是否正常。

If the hydraulic pump of the fully automatic concrete mixer truck outputs oil, we can check whether it works normally in time.

如不正常，有可能是壓力油路中的某個設備配件被卡在了其它原因，處于回油位置，導致壓力油路和溢流回路短路的情況發生，也可能是管接頭有松動的情況發生，當我們在油路中的某些設備漏油，或液壓缸、液壓馬達密封被損壞。

If it is abnormal, it may be that one of the equipment accessories in the pressure oil circuit is stuck in the oil return position for other reasons, resulting in short circuit of the pressure oil circuit and overflow circuit, or it may be that the pipe joint is loose, when some of our equipment in the oil circuit leaks oil, or the hydraulic cylinder and hydraulic motor seals are damaged.

排除的方法是直接拆掉相關設備進行清洗，看看是否有相應的設備損壞，該更換就更換，該檢查一下。

The elimination method is to directly remove the relevant equipment for cleaning to see if there is any damage to the corresponding equipment, and then replace it when necessary. It is time to check.

看看自動攪拌車的液壓泵是不是可以輸出液壓油的。如稱新型液壓泵，無液壓油，有可能是泵體有缺陷，讓吸油腔與壓油腔有相通的情況發生，失去了壓油能力，應及時找到更換。

Check whether the hydraulic pump of the automatic mixer can output hydraulic oil. If the new hydraulic pump is said to have no hydraulic oil, it may be that the pump body is defective and the oil suction chamber is connected with the oil pressure chamber. If the oil pressure capacity is lost, it should be replaced in time.

如果沒有新的液壓泵，沒有液壓油輸出，就有可能是轉向不當，部件磨損嚴重或損壞，及時更換。

If there is no new hydraulic pump and no hydraulic oil output, it is possible that the steering is improper and the components are seriously worn or damaged. Replace them in time.

全自動混凝土攪拌車的液壓系統可以設定正常壓力，有些管道或液壓缸在中間沒有壓力，可能是因為管路、小孔或節流閥、換向閥等部位堵塞。因此要仔細檢查檢查壓力是否有油通過，找出原因，但后來就排除了。

The hydraulic system of the fully automatic concrete mixer can be set to normal pressure. Some pipes or hydraulic cylinders have no pressure in the middle, which may be due to blockage of pipes, orifices or throttle valves, reversing valves and other parts. Therefore, it is necessary to carefully check whether there is oil passing through the pressure to find out the cause, but it was ruled out later.

攪拌車系統氣壓不足的原因就是這樣了，更多相關內容就來我們網站http://www.zgclmw.com咨詢吧！

This is the reason why the air pressure of the mixer system is insufficient. More relevant information can be found on our website http://www.zgclmw.com Consult!